St. Louis' humid summers, cold winters, and proximity to two major rivers make concrete moisture testing an important step before any flooring installation. The Orange Grounds LLC performs ASTM-standard moisture, vapor emission, and pH testing throughout the St. Louis metro.
Why Moisture Testing Matters in St. Louis
St. Louis sits near the confluence of the Mississippi and Missouri Rivers, where a humid continental climate brings hot, humid summers and cold winters with regular freeze-thaw cycles. That combination slows how quickly a concrete slab cures and can trap internal moisture for longer than contractors expect, particularly on slabs poured during the colder months or built on ground near the rivers where the water table runs high. Installing carpet, vinyl, hardwood, or coatings over an untested slab is a common cause of adhesive failure, cupping, and mold growth in the region — problems that cost far more to correct after installation than a moisture test would have cost beforehand.
With continued growth in Chesterfield, Florissant, and O'Fallon, more contractors across the metro are building moisture testing into their standard project timeline rather than treating it as an afterthought.
ASTM-Standard Testing Across the St. Louis Metro
The Orange Grounds LLC performs all major ASTM test methods required by flooring manufacturers and general contractors throughout St. Louis and its surrounding suburbs. ASTM F2170 internal relative humidity probe testing measures moisture deep within the slab and is the most widely specified method used today. We also perform ASTM F1869 calcium chloride moisture vapor emission rate (MVER) testing for projects that call for surface-level results. Every test includes ASTM F710 pH testing and porosity testing at no additional charge, giving you a complete picture of slab readiness in a single visit. See our full services page for complete details on each test method we offer.
Your Local ICRI-Certified Technician
Concrete moisture testing throughout the St. Louis metro — including Chesterfield, Florissant, and O'Fallon — is performed by Brandon Martin, ICRI-certified concrete moisture testing technician for The Orange Grounds LLC, headquartered in Huntsville, TX. Brandon brings the same ASTM-standard testing methods used across our full nine-state service area directly to your St. Louis-area project, with scheduling handled through our office.
Ready to Schedule Testing in St. Louis?
Contact us to book ASTM-standard concrete moisture testing anywhere in the St. Louis metro, or ask which test is right for your project.
Contact Us